|
|
Amgrow
Pty Ltd
PO Box 1085,
Penrith 2751
1800 682 221
|
MATERIAL SAFETY DATA SHEET
Hazardous
according to the criteria of NOHSC Australia.
Product
Name: Wettasoil
Hose On Deep Wetting Agent
Other Names: None.
Product Code: None
UN No: None allocated
Hazchem Code: None
allocated
Dangerous Goods Class: None
allocated
Sub Risk Class: None
allocated
Packaging Group: None
allocated
Poison Schedule: Not
Scheduled
Chemical Family: Detergent
Blend
Uses: A surfactant
for soil wetting
___________________________________________________________________________________________________
Appearance
& Odour: Colourless liquid, mild odour
Melting/softening point: No
specific data. Liquid at normal temperatures.
Boiling point and vapour pressure: Not
determined
Volatile materials: No
specific data. Expected to be low at 100°C.
Flashpoint: >100oC
(DIN 51758)
Specific gravity: 1.04
(23oC)
Solubility in water: Soluble
Corrosiveness: Not
corrosive.
pH: approx 7 (at
50g/L, 23oC)
__________________________________________________________________________________________________
Ingredients
| Chemical Entity | CAS No | Proportion % | Worksafe Exposure Limits TWA mg/m3 STEL mg/m3 |
| Propylene oxide-ethylene oxide block polymer enriched with Seaweed (20%) | 9003-11-6 | 15 | not set not set |
| Water | 7732-18-5 | to 100 | not set not set |
There are no known chronic effects associated with this material. The ingredients are not listed as carcinogenic in Worksafe’s document “Exposure Standards for Atmospheric Contaminants in the Occupational Environment” (May 1995).
Swallowed: Ingestion
may result in gastric disturbances
Eye: Eye contact may
result in slight irritation
Skin: Prolonged or
repeated skin contact may result in slight irritation
Inhalation: Not
expected to be an inhalation hazard at ambient temperatures
Ensure eye wash and safety
shower are readily available
Swallowed: Rinse mouth and then drink plenty of water
Eyes: If
this product comes into contact with eyes, hold open and wash with running water
for at least 15 minutes. Ensure irrigation under eyelids by occasionally lifting
them. Do not try to remove contact lenses unless trained
Skin: If product gets
on skin, immediately remove contaminated clothing and wash skin with soap and
water.
Advice to Doctor: Treat
symptomatically. Note the nature of this product. No known specific antidote
Risk Phrases are: R36 Irritating to eyes
A time weighted average (TWA) concentration for an 8-hour day, and 5-day week has not been established by Worksafe Australia for any of the major ingredients in this product. There is a blanket limit of 10mg/m3 for dusts or mists when limits have not otherwise been established. The nature of this product makes it unlikely that this level will be approached in normal use.
Ensure workplace is well ventilated
Respiratory
Protection: It is usually safe to not use a dust
mask or respirator protection on account of this product. However, if the
product is being used in dusty or confined conditions, use of a mask or
respirator may be preferred. For help in selecting suitable equipment, consult
AS/NZS 1715.
Protective Gloves: Impermeable
protective gloves should be worn when you are using this product. Failure to do
so will lead to irritation of the skin. For help in selecting suitable
equipment, consult AS 2161.
Eye Protection: Protective
eyewear should be worn when using this product. Eye contact may prove painful
and should be avoided. Consult AS1336 and AS/NZS 1337 for advice on Industrial
Eye Protection.
Clothing: This
product is essentially safe to use without special protective clothing. However,
its use is recommended as a good industrial practice. Clean overalls or
protective clothing should be worn. Consult AS2919 for advice on Industrial
Clothing.
Safety Boots: Wearing
safety boots in industrial situations is advisory. Consult AS/NZS2210 for advice
on Occupational Protective Footwear.
Always wash hands before smoking,
eating or using the toilet. Wash contaminated clothing and other protective
equipment before storing or re-using.
No special storage and transport requirements. Not classified as a dangerous good for storage and transport.This product has no UN classification. Not a Scheduled Poison. Containers should be kept tightly sealed in a dry place. This product is hygroscopic. Keep from extreme heat and open flames.
Must be incinerated or disposed
to approved landfill in accordance with local regulations. Do not discharge
product to water courses without pre-treatment (biological treatment plant).
Contaminated packs that cannot be cleaned should be disposed of in the same
manner as the contents. Uncontaminated packs can be reused.
In the event of a major spill, prevent spillage from entering drains or
watercourses. Wear full protective clothing including face mask, face shield and
gauntlets. All skin areas should be covered. Thoroughly launder protective
clothing before storage or re-use. See above under Personal Protection regarding
Australian Standards relating to personal protective equipment. Stop leak if
safe to do so, and contain spill. Absorb onto sand, vermiculite or other
suitable absorbent material. Sweep up and shovel or collect recoverable product
into labelled containers for recycling or salvage. Can be slippery on floors,
especially when wet. Recycle containers wherever possible. After spills, wash
area preventing runoff from entering drains. If a significant quantity of
material enters drains, advise emergency services. This material may be suitable
for approved landfill. Dispose of only in accord with all regulations. Advise
laundry of nature of contamination when sending contaminated clothing to
laundry.
There are no known unusual fire
or explosion hazards
Flashpoint: Not
flammable.
Flammability limits: Not
applicable. This product is not flammable.
Extinguishing Media: carbon
dioxide, dry chemical, foam, and water spray
Special Fire Fighting procedures: When
fighting fires involving significant quantities of this product, wear safety
boots, non-flammable overalls, gloves, hat, goggles, and respirator. All skin
areas should be covered.
Stability: This
product is unlikely to spontaneously decompose.
Polymerisation: This
product is unlikely to spontaneously polymerise.
Hazardous Decomposition Products: None
provided product is correctly processed
This MSDS is prepared in accord with the Worksafe Australia document “National Code of Practice for the Preparation of Material Safety Data Sheets”, 1994. File Code: Wettasoil Hose on.doc
|
Contact
Points: |
AUSTRALIA |
|
Police
and Fire Brigade: |
Dial
000 |
|
If
ineffective: |
Dial
1100 (Exchange) |
|
National
Poisons Information Centre: |
Dial
13 1126 (from anywhere in Australia) |
THIS MSDS SUMMARISES OUR BEST KNOWLEDGE OF THE HEALTH AND SAFETY HAZARD INFORMATION OF THE PRODUCT AND HOW TO SAFELY HANDLE AND USE THE PRODUCT IN THE WORKPLACE. EACH USER SHOULD READ THIS MSDS AND CONSIDER THE INFORMATION IN THE CONTEXT OF HOW THE PRODUCT WILL BE HANDLED AND USED IN THE WORKPLACE INCLUDING IN CONJUNCTION WITH OTHER PRODUCTS. IF CLARIFICATION OR FURTHER INFORMATION IS NEEDED TO ENSURE THAT AN APPROPRIATE RISK ASSESSMENT CAN BE MADE, THE USER SHOULD CONTACT THIS COMPANY. THE RESPONSIBILITY FOR PRODUCTS SOLD IS SUBJECT TO OUR STANDARD TERMS AND CONDITIONS, A COPY OF WHICH IS SENT TO OUR CUSTOMERS AND IS ALSO AVAILABLE ON REQUEST.
Please
read all labels carefully before using product.
This
MSDS prepared by Kilford & Kilford Pty Ltd July 2004
Revised July 2007
Copyright
© Kilford & Kilford Pty Ltd,
2004
Phone (02) 9516 2079