|

|
Envirogreen
Pty Ltd
ABN 22 069 900 456
PO Box 1085,
Penrith 2751
1800 682 221
|
MATERIAL SAFETY DATA SHEET
Not classified as hazardous according to the
criteria of Worksafe Australia.
l IDENTIFICATION
Product Name:
Organix
Azalea, Camellia and Gardenia Fertiliser
Other Names: None.
Product Code: None.
UN No: None allocated Hazchem Code: None allocated
Dangerous Goods Class: None allocated
Sub Risk Class: None allocated
Packaging Group: None allocated
Poison Schedule: Not scheduled.
Chemical Family: Blend of ingredients (see below).
Uses: Garden fertiliser.
Physical Appearance & Properties
Appearance & Odour: Brown crumbles with
red and white flecks. Characteristic odour.
Melting/softening point: Decomposes before melting.
Boiling point and vapour pressure: Not applicable.
Volatile materials: No specific data. Expected to be low at 100°C.
Flashpoint: Not flammable.
Specific gravity: No data.
Solubility in water: Slightly soluble.
Corrosiveness: Not corrosive.
Ingredients
| Chemical Entity |
CAS No |
Proportion % |
Worksafe Exposure Limits
TWA mg/m3
STEL mg/m3 |
| Poultry Manure |
not set |
30-60 |
not set
not set |
| Diammonium phosphate
|
7783-28-0 |
1-10 |
not
set
not set |
| Ammonium sulphate
|
7783-20-2
|
10-30 |
not
set
not set |
| Potassium chloride
|
7447-40-7
|
10-30
|
not
set
not set |
This is a commercial product whose exact ratio of components may vary. Trace
quantities of impurities are also likely.
_____________________________________________________________________________________________________
ll HEALTH HAZARD DATA
Health Effects:
No specific data is available for the product for chronic
exposure symptoms. The ingredients are not listed as carcinogenic in Worksafes
document "Exposure Standards for Atmospheric Contaminants in the Occupational
Environment" (May 1995).
Acute Effects:
This product is virtually non-toxic by normal routes of exposure. There is
no data to suggest that chronic exposure has any adverse health effects in the
way of carcinogenicity, mutagenicity or reproductive effects. However, as with
many products of organic origin, it is possible that this product may contain
pathogenic micro-organisms.
Swallowed: Data suggests that this product should present no significant
problems to typical persons if used as intended.
Eye: This product may irritate eyes. However, it is unlikely to cause
any more than mild transient discomfort. It is also unlikely to cause any significant
lasting effects.
Skin: Data suggests that this product should present no significant
problems to typical persons if used as intended.
Inhalation: Data suggests that this product should present no significant
problems to typical persons if used as intended.
For Ammonium sulfate LD50 Oral (Rat) 3000mg/kg For potassium chloride
LD50 Oral (Rat) 2430mg/kg
First Aid:
If poisoning occurs, contact a Doctor or Poisons Information
Centre.
Eyes: If product gets in eyes, wash material from them with running
water. If they begin watering or reddening, take special care in washing thoroughly.
Skin: If product gets on skin, wash skin to remove material. No further
measures should normally be required.
Inhalation: No first aid measures normally required. However, if vapours
or dusts have been inhaled, and irritation has developed, remove to fresh air
and observe until recovered. If irritation becomes painful or persists more
than about 30 minutes, seek medical advice.
Advice to Doctor: Treat symptomatically. Note the nature of this product.
___________________________________________________________________________________________________________
lll PRECAUTIONS FOR USE
Exposure Standards:
A time weighted average (TWA) concentration for an 8
hour day, and 5 day week has not been established by Worksafe Australia for
any of the major ingredients in this product. There is a blanket limit of 10mg/m3
for dusts or mists when limits have not otherwise been established. The nature
of this product makes it unlikely that this level will be approached in normal
use.
Engineering Controls:
In industrial situations, concentration values below the TWA value should be
maintained. Values may be reduced by process modification, use of local exhaust
ventilation, capturing substances at the source, or other methods. If you believe
air borne concentrations of mists, dusts or vapours are high, you are advised
to modify the process or environment to reduce the problem.
Personal Protection:
Respiratory Protection: It is usually safe to not use a dust mask or
respirator protection on account of this product. However, if the product is
being used in dusty or confined conditions, use of a mask or respirator may
be preferred. For help in selecting suitable equipment, consult AS/NZS 1715.
Protective Gloves: Protective gloves are not normally necessary when
using this product. However, it is always prudent to wear gloves. For help in
selecting suitable equipment, consult AS 2161.
Eye Protection: Protective eyewear is not normally necessary when using
this product. However, it is always prudent to use protective eyewear. Consult
AS1336 and AS/NZS 1337 for advice on Industrial Eye Protection.
Clothing: This product is essentially safe to use without special protective
clothing. However, its use is recommended as a good industrial practice. Consult
AS2919 for advice on Industrial Clothing.
Safety Boots: Wearing safety boots in industrial situations is advisory.
Consult AS/NZS2210 for advice on Occupational Protective Footwear.
Always wash hands before smoking, eating or using the toilet. Wash contaminated
clothing and other protective equipment before storing or re-using.
__________________________________________________________________________________________________________
lV SAFE HANDLING INFORMATION
Storage & Transport
No special storage and transport requirements. This product
has no UN classification. Not a Scheduled Poison. Containers should be kept
closed in order to minimise contamination. Keep from extreme heat and open flames,
and make sure that the product does not come into contact with substances listed
under "Materials to avoid" below.
Spills & Disposals
Minor spills do not normally need any special cleanup
measures. In the event of a major spill, prevent spillage from entering drains
or water courses. As a minimum, wear overalls, goggles and gloves. Stop leak
if safe to do so, and contain spill. Sweep up and shovel or collect recoverable
product into labelled containers for recycling or salvage. After spills, wash
area preventing runoff from entering drains. If a significant quantity of material
enters drains, advise emergency services. Full details regarding disposal of
used containers, spillage and unused material may be found on the label. If
there is any conflict between this MSDS and the label, instructions on the label
prevail. Dispose of only in accord with all regulations.
Fire & Explosion Hazard
There is no risk of an explosion from this product under
normal circumstances if it is involved in a fire.
Flashpoint: Not flammable.
Flammability limits: Not applicable. This product is not flammable.
However, may smolder for lengthy periods.
Extinguishing Media: carbon dioxide, dry chemical, foam, water fog.
Special Fire Fighting procedures: When fighting fires involving significant
quantities of this product, wear safety boots, non-flammable overalls, gloves,
hat and preferably, goggles.
Unusual Fire & Explosion Hazards: Fire decomposition products from
this product may form toxic mixtures in confined spaces.
Stability: This product is unlikely to spontaneously decompose.
Polymerisation: This product is unlikely to spontaneously polymerise.
Decomposition Products: Carbon dioxide, and if combustion is incomplete,
carbon monoxide and smoke. Water.
Materials to avoid: strong oxidising agents.
________________________________________________________________________________________________________________-
V OTHER INFORMATION
This MSDS is prepared in accord with the Worksafe Australia document "National
Code of Practice for the Preparation of Material Safety Data Sheets", 1994.
File Code: Azalea&Camellia.kng
| Contact Points: |
AUSTRALIA |
| Police and Fire Brigade: |
Dial 000 |
| If ineffective: |
Dial 1100 (Exchange) |
| National Poisons Information
Centre: |
Dial 13 1126 (from anywhere
in Australia) |
THIS MSDS SUMMARISES OUR BEST KNOWLEDGE OF THE HEALTH AND SAFETY HAZARD INFORMATION
OF THE PRODUCT AND HOW TO SAFELY HANDLE AND USE THE PRODUCT IN THE WORKPLACE.
EACH USER SHOULD READ THIS MSDS AND CONSIDER THE INFORMATION IN THE CONTEXT
OF HOW THE PRODUCT WILL BE HANDLED AND USED IN THE WORKPLACE INCLUDING IN CONJUNCTION
WITH OTHER PRODUCTS. IF CLARIFICATION OR FURTHER INFORMATION IS NEEDED TO ENSURE
THAT AN APPROPRIATE RISK ASSESSMENT CAN BE MADE, THE USER SHOULD CONTACT THIS
COMPANY. THE RESPONSIBILITY FOR PRODUCTS SOLD IS SUBJECT TO OUR STANDARD TERMS
AND CONDITIONS, A COPY OF WHICH IS SENT TO OUR CUSTOMERS AND IS ALSO AVAILABLE
ON REQUEST.
Please read all labels carefully before using product.
This MSDS prepared by Kilford & Kilford Pty Ltd May, 1998.
Updated 30th July 2007
Copyright © Kilford & Kilford Pty Ltd, 1998 Phone (02)9251 4532