|

|
Amgrow
Pty Ltd
ABN 22 069 900 456
PO Box 1085,
Penrith 2751
1800 682 221
|
MATERIAL SAFETY DATA SHEET
Not classified as hazardous according to the criteria of Worksafe Australia.
l IDENTIFICATION
Product Name:
Amgrow
Organix Gypsum
Other Names: None.
Product Code: None.
UN No: None allocated Hazchem Code: None allocated
Dangerous Goods Class: None allocated
Sub Risk Class: None allocated
Packaging Group: None allocated
Poison Schedule: Not scheduled.
Chemical Family: Mineral.
Uses: Soil conditioner.
Physical Appearance & Properties
Appearance & Odour: Grey-brown
crystalline solid. No odour.
Melting/softening point: No specific data. Solid at normal temperatures.
Boiling point and vapour pressure: Not applicable.
Volatile materials: Water component.
Flashpoint: Does not burn.
Specific gravity: 2.32
Solubility in water: Insoluble.
Corrosiveness: Not corrosive.
Ingredients
| Chemical Entity |
CAS No |
Proportion % |
Worksafe Exposure Limits
TWA mg/m3 STEL
mg/m3 |
| Calcium sulfate dihydrate |
10101-41-4 |
>85 |
not set
not set |
| Water |
7732-18- 5 |
to 100 |
not
set not
set |
This is a commercial product whose exact ratio of components may vary. Trace
quantities of impurities are also likely.
__________________________________________________________________________________________________________________
ll HEALTH HAZARD DATA
Health Effects:
No specific data is available for the
product for chronic exposure symptoms. The ingredients are not listed as
carcinogenic in Worksafe’s document "Exposure Standards for Atmospheric
Contaminants in the Occupational Environment" (May 1995).
Acute Effects:
Swallowed: Data suggests that this
product should present no significant problems to typical persons if used as
intended.
Eye: Data suggests that this product should present no significant
problems to typical persons if used as intended.
Skin: Data suggests that this product should present no significant
problems to typical persons if used as intended.
Inhalation: Data indicates that this product may be irritating if
inhaled. May lead to minor discomfort which should quickly disappear once
exposure has ceased.
First Aid:
If this product gets into mouth, wash out
with water. No further measures should be necessary.
Eyes: If product gets in eyes, wash eyes to remove material. No further
measures should normally be required.
Skin: If product gets on skin, wash skin to remove material. No further
measures should normally be required.
Inhalation: No first aid measures normally required. However, if dusts
have been inhaled, and irritation has developed, remove to fresh air and observe
until recovered. If irritation becomes painful or persists more than about 30
minutes, seek medical advice.
Advice to Doctor: Treat symptomatically. Note the nature of this product.
___________________________________________________________________________________________________________________
lll PRECAUTIONS FOR USE
Exposure Standards:
A time weighted average (TWA)
concentration for an 8 hour day, and 5 day week has not been established by
Worksafe Australia for any of the major ingredients in this product. There is a
blanket limit of 10mg/m3 for dusts or mists when limits have not
otherwise been established. The nature of this product makes it unlikely that
this level will be approached in normal use.
Engineering Controls:
In industrial situations, concentration
values below the TWA value should be maintained. Values may be reduced by
process modification, use of local exhaust ventilation, capturing substances at
the source, or other methods. If you believe air borne concentrations of mists,
dusts or vapours are high, you are advised to modify the process or environment
to reduce the problem.
Personal Protection:
Respiratory Protection: The use of
a dust mask is suggested when this product is being used, especially if in
confined or dusty spaces. For help in selecting suitable equipment, consult
AS/NZS 1715.
Protective Gloves: Protective gloves are not normally necessary when
using this product. However, it is always prudent to wear gloves. For help in
selecting suitable equipment, consult AS 2161.
Eye Protection: Protective eyewear is not normally necessary when using
this product. However, it is always prudent to use protective eyewear. Consult
AS1336 and AS/NZS 1337 for advice on Industrial Eye Protection.
Clothing: This product is essentially safe to use without special
protective clothing. However, its use is recommended as a good industrial
practice. Consult AS2919 for advice on Industrial Clothing.
Safety Boots: Wearing safety boots in industrial situations is advisory.
Consult AS/NZS2210 for advice on Occupational Protective Footwear.
Always wash hands before smoking, eating or using the toilet. Wash contaminated
clothing and other protective equipment before storing or re-using.
_____________________________________________________________________________________________________________________
lV SAFE HANDLING INFORMATION
Storage & Transport
No special storage and transport
requirements. This product has no UN classification. Not a Scheduled Poison.
Containers should be kept closed in order to minimise contamination. Keep from
extreme heat and open flames, and make sure that the product does not come into
contact with substances listed under "Materials to avoid" below.
Spills & Disposals
Minor spills do not normally need any
special cleanup measures. In the event of a major spill, prevent spillage from
entering drains or water courses. As a minimum, wear overalls, goggles and
gloves. Stop leak if safe to do so, and contain spill. Sweep up and shovel or
collect recoverable product into labelled containers for recycling or salvage.
Recycle containers wherever possible. After spills, wash area preventing runoff
from entering drains. If a significant quantity of material enters drains,
advise emergency services. This material may be suitable for approved landfill.
Dispose of only in accord with all regulations.
Fire & Explosion Hazard
There is no risk of an explosion from
this product under normal circumstances if it is involved in a fire.
Flashpoint: Does not burn.
Flammability limits: Not applicable. This product does not burn.
Extinguishing Media: This product does not burn. Use extinguishing media
suited to the materials that are burning.
Special Fire Fighting procedures: When fighting fires involving
significant quantities of this product, wear safety boots, non-flammable
overalls, gloves, hat and preferably, goggles.
Unusual Fire & Explosion Hazards: This product is unlikely to
decompose at temperatures normally achieved in a fire.
Stability: This product is unlikely to spontaneously decompose.
Polymerisation: This product is unlikely to spontaneously polymerise.
Decomposition Products: No decomposition products are expected at
temperatures normally achieved in a fire.
Materials to avoid: No particular incompatibilities.
_____________________________________________________________________________________________________________________
V OTHER INFORMATION
This MSDS is prepared in accord with the Worksafe Australia document
"National Code of Practice for the Preparation of Material Safety Data
Sheets", 1994. File Code: orggyp
| Contact Points: |
AUSTRALIA |
| Police and Fire Brigade: |
Dial 000 |
| If ineffective: |
Dial 1100 (Exchange) |
| National Poisons
Information Centre: |
Dial 13 1126 (from
anywhere in Australia) |
THIS MSDS SUMMARISES OUR BEST KNOWLEDGE OF THE HEALTH AND SAFETY HAZARD
INFORMATION OF THE PRODUCT AND HOW TO SAFELY HANDLE AND USE THE PRODUCT IN THE
WORKPLACE. EACH USER SHOULD READ THIS MSDS AND CONSIDER THE INFORMATION IN THE
CONTEXT OF HOW THE PRODUCT WILL BE HANDLED AND USED IN THE WORKPLACE INCLUDING
IN CONJUNCTION WITH OTHER PRODUCTS. IF CLARIFICATION OR FURTHER INFORMATION IS
NEEDED TO ENSURE THAT AN APPROPRIATE RISK ASSESSMENT CAN BE MADE, THE USER
SHOULD CONTACT THIS COMPANY. THE RESPONSIBILITY FOR PRODUCTS SOLD IS SUBJECT TO
OUR STANDARD TERMS AND CONDITIONS, A COPY OF WHICH IS SENT TO OUR CUSTOMERS AND
IS ALSO AVAILABLE ON REQUEST.
Please read all labels carefully before using product.
This MSDS prepared by Kilford & Kilford Pty Ltd May 2004
Revised July 2007
Copyright © Kilford & Kilford Pty Ltd, 1998 Phone (02)9251 4532